Serving New Braunfels and Comal and Guadalupe County since 2003
Licensed & InsuredFree EstimatesMon-Fri 7am-5pm
(830) 221-9409 Licensed & Insured
Book a Free Foundation Inspection
Pier and Beam Foundation Repair in New Braunfels, TX

Pier and Beam Foundation Repair in New Braunfels, TX

New Braunfels Superior Foundation Repair offers professional pier and beam foundation repair in New Braunfels, TX with 23 years of work in the crawl spaces under frame houses. We re-shim and level floors with steel shims, replace rotted cedar stumps with concrete pier pads, and sister or replace soft joists, sills and girders. Each new pier pad costs $350 to $600.

Pier and beam houses move differently from slabs. They sag between supports, rot where wood sits too close to damp dirt, and drift with the seasons as the soil under each pad shifts. We fix the supports first, then level the floors, and every re-shim and level carries a 3-year adjustment warranty.

Get a FREE Estimate

Or call (830) 221-9409

  • Steel shims only, never cedar shingles or wood wedges
  • Rotted framing replaced with pressure-treated lumber
  • 3-year adjustment warranty on every re-shim and level
  • Photos of every pad and beam we touch in the crawl space

Pier and Beam Foundation Repair Options

Pier and Beam Re-Shimming and Leveling

Pier and Beam Re-Shimming and Leveling

When the pads are sound but the floor has sagged, the fix is shims. We jack the girder, pull the crushed wood and set steel shims cut to height on each pad. A whole-house re-shim and level runs $1,400 to $4,800 and usually takes 1 to 2 days.

Concrete Pier Pad Replacement

Concrete Pier Pad Replacement

A lot of older houses here still stand on cedar stumps set in the dirt generations ago. Cedar lasts, but not forever, and once a stump rots the floor drops over it. We dig it out, set a new concrete pier pad on compacted base and shim the beam to height. Each new pad runs $350 to $600.

Sill Plate and Girder Replacement

Sill Plate and Girder Replacement

Sills and girders rot where gutters overflow, where the crawl space stays damp, or where wood sits right on masonry. We shore the floor, cut out the bad section and replace it with pressure-treated lumber at $45 to $95 a linear foot.

Floor Joist Sistering

Floor Joist Sistering

A joist that has cracked, been notched by a plumber or sagged gets a new full-length joist bolted alongside it. Sistering keeps the original framing in place, which matters on older houses with tongue-and-groove floors and plaster walls.

Perimeter Beam and Limestone Wall Repair

Perimeter Beam and Limestone Wall Repair

Some older houses sit on a perimeter beam or a limestone foundation wall with interior piers in the middle. When the perimeter drops, we pier under it with pressed pilings or a bell-bottom pier and repoint cracked stone with a soft mortar.

Crawl Space Moisture Control

Crawl Space Moisture Control

Standing water and damp dirt rot wood and soften the soil under the pads. We fix the drainage that's feeding it, lay a vapor barrier over the dirt once it dries, and make sure the foundation vents can move air.

Before and After

Rotted cedar stumps and wood scrap shims under a sagging girder in a New Braunfels crawl space
New concrete pier pads with steel shims under a straight girder in a pier and beam crawl space
Typical before and after: rotted cedar stumps under a sagging girder replaced with concrete pier pads and steel shims.

Signs of Pier and Beam Foundation Problems

Pier and beam trouble usually shows up in the floor before it shows up in the walls. Bouncy or spongy spots, a dip you can feel walking down the hall, gaps under baseboards and doors dragging on one side are the common ones.

Look outside too. Skirting pulling loose, a sill that's dark and soft, or a vent sitting in mud all point the same way. If you can reach the crawl space access, a flashlight look at the pads is worth a lot. Cracked blocks, leaning stumps and shims flattened like pancakes are all things we replace.

Older Frame Houses and Historic Homes

Some of the oldest houses around downtown New Braunfels were built on piers over a crawl space, with cedar, limestone and wood framing the German settlers had on hand. After 100 years or more, that framing has taken a set and isn't straight anymore.

We don't level those houses to a laser. We lift in small stages and stop where the doors work and the plaster holds. Pushing old framing to dead flat cracks plaster and racks window frames.

Houses in the city's four local historic districts also need a Certificate of Alteration before exterior work like new skirting, a new access opening or masonry repointing. Most of our work happens under the house, out of sight, but the paperwork still comes before the shovel.

Crawl Space Clearance and Wood That Rots

The residential code wants untreated wood joists at least 18 inches above the dirt and girders at least 12 inches up. Plenty of older houses don't meet that, and the wood that's too close is usually the wood that's rotting.

When we replace a sill, joist or girder in a low crawl space, it goes back as pressure-treated lumber. Where we can, we dig out some dirt to get air moving under the house. It isn't glamorous work. It's the difference between fixing the floor once and fixing it again.

Our Pier and Beam Repair Process

  1. Crawl space inspection

    We go under the house with a light and a camera, check every pad, shim, beam and sill, and take manometer readings across the floors.

  2. Written plan

    You get photos, a sketch and a written estimate listing every pad, shim and board we plan to replace, good for 30 days.

  3. Shore and replace

    We shore the floor, pull rotted stumps and wood, set new concrete pads and replace bad framing with pressure-treated lumber.

  4. Shim and level

    We jack the girders in small stages, set steel shims to height and check the floors again with the manometer.

  5. Walkthrough

    We walk the house with you, open and close the doors, and leave you the readings, the photos and the 3-year adjustment warranty.

Pier and Beam Foundation Repair FAQs

How much does pier and beam foundation repair cost?

A whole-house re-shim and level runs $1,400 to $4,800. New concrete pier pads add $350 to $600 each, and sill or girder replacement runs $45 to $95 a linear foot. We price each item separately so you can see where the money goes.

How often does a pier and beam house need re-shimming?

It depends on the soil and the drainage. Houses on clay can drift enough over a few years that the floors need a touch-up. That's why every re-shim and level we do comes with a 3-year adjustment warranty.

Should I convert my pier and beam house to a slab?

Almost never. It costs far more than repairing the supports, and you lose the crawl space access that makes plumbing and wiring repairs easy. A pier and beam house with sound pads and dry wood is a good foundation.

Can you work in a really low crawl space?

Usually. Where there isn't room to crawl, we dig a trench to the work or cut an access through a closet floor. We'll tell you which one before the job starts.

Why not just use wood shims?

Wood shims crush and rot, especially in a damp crawl space. Steel shims stay at the height we set. We use steel on every pad.

Get Your Crawl Space Looked At

Call (830) 221-9409 or send the form. We'll go under the house, photograph what's there and give you a written list of what needs replacing.